request to quote
Leave Your Message
Anionic Polyacrylamide for Tin ore tailings water recovery
Polyacrylamide for Mining & Mineral Processing
Products Categories
Featured Products

Anionic Polyacrylamide for Tin ore tailings water recovery

Bluwat APAM polyacrylamide powder is a candidate flocculant for tin ore tailings water recovery. Grade and dose require testing with the buyer’s process sample.

    In brief

    For tin ore tailings water recovery, APAM is a screening option: select the actual grade from settling and clarity trials on the plant stream. The Blufloc series TDS lists maximum 0.05% residual monomer as a typical or preparation property, but it does not identify a mining-specific SKU or guarantee an operating result.

    Where this polymer fits

    Tin ore processing may generate fine tailings from gravity and other beneficiation steps; their sedimentation behavior depends on the mixed stream.

    Screen anionic grades with combined plant tailings, including changes in ore and recycle water quality.

    Blufloc series reference properties

    ◆ Appearance: Off white granular powder
    ◆ Ionic type: Anionic
    ◆ Particle size: 20–100 mesh
    ◆ Molecular weight: 5–25 million, typical series range
    ◆ Anionic degree: 5–100%, typical series range
    ◆ Solid content: 89% minimum
    ◆ Residual monomer: 0.05% maximum
    ◆ pH of 1% aqueous solution: 6–8
    ◆ Working solution: 0.1–0.5% powder concentration in water
    ◆ Storage and shelf life: 0–35 °C; two years as stated in the series TDS
    ◆ Packaging: 25 kg PE or kraft paper bag with inner plastic liner; 750 kg net big bag, subject to order confirmation
    PAM Mining 2026.jpg

    How to evaluate it for tin ore tailings water recovery

    Measure recovered water clarity, settling time and underflow handling for typical and peak load samples. The winning grade should return usable water without impairing solids discharge.

    Solution preparation and dosing

    Prepare the powder as a 0.1–0.5% solution by slowly dispersing it into mixing water. The series TDS advises approximately one hour of agitation, typically 200–400 rpm; avoid lumps and unnecessarily high shear. Trial dose must be established on site: 0.1–0.5% describes the prepared solution concentration, not a dose in ppm or kilograms per tonne. Introduce the solution where it can contact the slurry before the settling or separation equipment; confirm the exact injection point through testing.

    What to send with an inquiry

    Share the beneficiation route, tailings solids, recycle demand and particle size. Include representative sample availability, treatment flow and current chemical program so the technical team can suggest grades for comparison.

    Available packaging in the series TDS includes 25 kg kraft paper bag; confirm the packaging for the quoted grade and destination.

    Buyer questions

    Is APAM the right polymer for tin ore tailings water recovery? It is a candidate, not an automatic choice. Screen anionic grades with combined plant tailings, including changes in ore and recycle water quality. A comparison with other ionic grades may be warranted if the site sample responds poorly.

    What should the plant measure in a jar test? Measure recovered water clarity, settling time and underflow handling for typical and peak load samples. The winning grade should return usable water without impairing solids discharge.

    Is 0.1–0.5% the plant dosage? No. It is the TDS range for preparing the working solution. Determine the addition rate from slurry solids, water chemistry and the plant’s equipment; request a grade-specific recommendation from sales.

    Confirm the offered grade and documents

    Ask Bluwat sales to confirm the recommended APAM grade, the current grade-specific TDS, COA and SDS, and the actual specifications for the offered lot.

    Leave Your Message