AI Data Center Liquid Cooling Reshapes Water Treatment Priorities
New cooling designs can reduce evaporative water consumption while increasing the importance of fluid cleanliness, material compatibility and system maintenance.
A new announcement from NVIDIA highlights how AI infrastructure development is changing the water treatment requirements of data centers. On October 21, 2026, the company said European infrastructure partners were adopting its DSX AI Factory Platform, whose reference designs combine closed loop liquid cooling with dry coolers to reduce facility cooling water consumption to near zero. [1]
NVIDIA estimates that a deployment at a scale of 2 gigawatts could save 54 million liters of water per day compared with conventional cooling tower systems. This is a company estimate for a specified design comparison, rather than a measured saving that applies to every data center. Local climate also affects whether supplemental mechanical cooling is needed during the hottest periods. [1]
For the water treatment sector, the development suggests a change in the type of work required. Reduced evaporative consumption can coexist with continuing requirements for clean cooling circuits, compatible fluids and documented maintenance.
Understanding the scope of cooling water savings
Liquid cooling describes how heat is collected from computing equipment. The facility still needs a way to release that heat to the environment. Combining liquid cooling with dry heat rejection avoids the continuous evaporation associated with cooling towers. A liquid cooled facility that uses evaporative heat rejection can still consume water. [1]
Microsoft described a similar direction in December 2024, reporting a new design that circulates water between servers and chillers without evaporating it for cooling. Its announcement also explained that water remains necessary for uses such as kitchens and restrooms. [2]
Microsoft acknowledged an energy tradeoff when replacing evaporative systems with mechanical cooling. Project assessments therefore need to consider both water and electricity use under local operating conditions. [2]
Different cooling circuits require different treatment
In many liquid cooling installations, a coolant distribution unit separates the facility water system from the technology cooling system serving the IT equipment. Heat passes through a heat exchanger while the two fluids remain separate. Lenovo describes this arrangement in its direct water cooling guidance, allowing eAch circuit to use an appropriate fluid. [3]
The facility circuit and the server circuit can consequently have different requirements for water chemistry, filtration and maintenance. Treatment decisions must reflect the materials and equipment in the specific circuit. A chemistry program suitable for a cooling tower cannot automatically be transferred to a server cooling loop. [3]
For cold plate systems, the equipment supplier's approved coolant and cleanliness requirements should guide fluid selection. Operators need defined acceptance limits and sampling procedures rather than a generic water quality target for every installation. [3, 4]
Commissioning becomes part of water quality control
The Open Compute Project's 2025 guidance for modular technology cooling systems gives particular attention to cleanliness during fabrication, delivery, installation and commissioning. It identifies cold plates with microchannels as especially demanding applications for fluid cleanliness and chemical stability. [4]
The guidance covers removing fabrication residues, cleaning and flushing pipework, protecting assemblies against contamination, and maintaining fluid integrity as equipment is added. These activities create a practical role for specialist contractors working to the cooling system supplier's procedures. [4]
After commissioning, routine fluid testing and monitoring help identify deterioration. Lenovo's guidance discusses monitoring water chemistry, corrosion and turbidity alongside maintenance of the cooling fluid. The relevant instruments and inspection intervals depend on the installation. [3]
Implications for the water treatment industry
Taken together, these developments suggest that suppliers should assess opportunities by cooling architecture and operating requirements. An installation using dry heat rejection may have limited demand for cooling tower chemicals, while still requiring specialist fluid management and filtration services.
For contractors and chemical suppliers, the useful starting point is the project specification. Defining which circuit is being treated, who approves the fluid and how performance will be verified provides a more reliable basis for participation than estimating demand from computing caPACity alone.
About Bluwat Chemicals
Bluwat Chemicals manufactures coagulants, flocculants and specialty products for water and Wastewater Treatment. Its portfolio includes polyaluminium chloride, PolyDADMAC, polyamine and polyacrylamide. In data center water projects, any evaluation of these products should focus on a defined treatment process, such as source water clarification, rather than assume suitability for server cooling fluids.










